Automatic feeding mixers to prevent pipe blockages It is important to master the correct feeding machine. The correct way is for the material to form a certain gas-matter mixing ratio between the suction port and the air, and evenly flows into the feeder under the impetus of the airflow. At this point, we need to design the material gun with a gas replenishment function. If the material backlog is too long, it may be hard. At this time, it is necessary to install an oscillator on the material gun to crush the clumped material. This model uses a walking engine 490 booster 79 horsepower, tank diameter 1.6 meters, depth 0.6 meters, bucket 62 cm depth 70 cm, weighted wheel side reduction bridge air brake, tire model 20.5/70-16, stepless speed, hydraulic outlet discharge.