Table side boarding bridge Product introduction DCQT-6T manual mechanical table side boarding bridge, no need to dig a pit, simple structure, but the adjustment plate range is small. Suitable for loading and unloading platforms that have been built but have not been preset for foundation pits. The table-side boarding bridge has two modes of operation: mechanical and hydraulic, and the mechanical type can be upgraded to a hydraulic type. It can be customized according to the customer's site situation! (The table length, width, load capacity, manual or hydraulic type can be customized!) Parameters Configuration Rated load-Dynamic load: 6000kg Height adjustment range: +150mm/ -150mm Board width: 1830mm/6ft Board length: 400mm Countertop size L*W: 1830mm*900mm Fixed plate size L*W: 1830mm*200mm Product Features Countertop structure: diamond pattern plate, bottom reinforcement Ribbed plate structure: patterned plate, reinforced arch bridge structure Front hinge: tubular hinge, seamless tube, axle pin rear hinge: tubular hinge, seamless tube, shaft pin safety maintenance support rod: ejector rod type anti-collision glue: laminated reinforced rubber anti-collision block, size 300mmX200mmX100mm paint: sandblasting surface treatment, one bottom and two sides marine paint pressure spring: Benchside boarding bridge structure with manual lever and connecting rod system Schematic 02 table side boarding bridge manual mechanical operation demonstration 02 table side boarding bridge manual mechanical main structural parts are made of high-strength non-slip patterned steel plate and profile close welding, the countertop skeleton is made of special I-beam, so that the countertop stress is more uniform, and the torque of the skeleton is reduced, and the bearing capacity is 2 times higher than the traditional channel steel, more firm and durable. Steel structural parts undergo strict surface treatment for shot blasting to remove rust. 02