Curbside stone manufacturers believe that during construction, the line must be hung up for construction, according to the side plane top surface shows the high standard line tightened, according to the line code to build the side flat stone, the side flat stone should be stable, do not fit back and forth, the side top line is straight and smooth, no wrong teeth phenomenon, no wrong teeth on the plane, no wrong teeth inside and outside. 2. Stone requires seat slurry masonry. The seat slurry is dense, and it is strictly forbidden to block the masonry; 3. The dislocation of the stone joint is no more than 1mm; the side stone and the flat stone must be evenly missewn in the middle. 4. The flat side stone should meet the design requirements in size and finish. The appearance is beautiful. The side stone of the bend should be processed according to the design radius. During masonry, the linear shape is smooth, smooth, and the seam is tight. Curved side stones must be manually chiseled and polished. 025. Analysis of roadside stone joints: When seaming, it is necessary to hang the thread again, remove the debris in the side stone seam, moisten it with water, and then fill the seam with 1:2.5 cement mortar and dry it. 026. Stone manufacturers analyze roadside stone joints and properly water and maintain them after installation. 02